SEMI-ELECTRIC STACKER POWER UNIT

This power unit is specially designed for Semi-Electric Stacker,Hydraulic Lifter Remover,The manual unloading valve is equipped with manual micro switch,The lifting and falling of the stacker are controlled by the handle of the unloading valve, Electric Hydraulic Valve For Tractor,and the falling speed is automatically controlled by the built-in pressure compensating throttle valve.

Model Specifications

Type 型号	Motor 电机	Pump Displacemen t 泵排量(cc/r)	Tank Capacit y 油箱容积(L)	Pressure 压力 (MPa)	Mounting 安装方式	Oil Port 油口尺寸	L(mm)
HPU1 -06ADAHGSAFG(Y)D	DC12V 1.6Kw 2500rpm	1.6	5	20	Lateral Horizontal 侧卧式	G3/8" (可定制Or Customize)	270
HPU1 -06ADAHGSAFH(Y)D		1.6	6				300
HPU1-06BFAIGSAFH(Y)D	DC24V 2.2Kw 2700rpm	2.1	6				300
HPU1-06BFAKGSAFJ(Y)D		2.6	8				370

Special Notes

1、 For different flow rate pump, pressure and motor power, please check the ordering guidance.

2、 This motor is based on gap working system S2=2 ~ 4min(continuous working time), so it cannot run continuously.

3、 Before installation, the cylinder, oil pipe, joint and other hydraulic components must be cleaned and free from any impurities.

4、 The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities. HM46 hydraulic oil is recommended.

5、 This hydraulic power pack is suitable for horizontal installation.

6、 Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

7、 The hydraulic oil should be replaced after the first 100 hours* use of the system, and change the oil every 3,000 hours after that.

Contact us if you need more details on Liftgate Hydraulic Power Unit Cylinder. We are ready to answer your questions on packaging, logistics, certification or any other aspects about John Deere Two Cylinder Power Unit、Alternate Power Unit. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Old Products